Team Associated RC10B5 Build – Bag F Slipper Clutch


Assembling the slipper clutch is quite easy, however there are few points to pay attention to.

Team Associated RC10B5 Build – Bag F Slipper Clutch Articles

My build notes:

  • At this point, you should know what gearing you’ll use. The kit comes with a 72T and a 81T spur gears. The spur gear to use depends of your motor and your track. Refer to the “Motor Gearing“ section of the instructions manual at page 18.
    Team Associated RC10B5 Build – Bag F Slipper Clutch Articles
  • The inner slipper pad must be perfectly inserted into the spur gear.
  • Assembling the slipper clutch could be a little tricky, make sure all the slipper pads are perfectly aligned and nothing wobbles when spinning the spur gear.
    Team Associated RC10B5 Build – Bag F Slipper Clutch Articles
  • The slipper clutch nut should be flush with the top shaft for stock adjustment.
    Team Associated RC10B5 Build – Bag F Slipper Clutch Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

*